From: Ernst_Wahl [wahl@dcf105.agere.com]
Sent: Tuesday, January 14, 2003 11:14 AM
To: STIL. 4 (E-mail)
Subject: stds-1450.4: Teleconference Minutes 1/14/2003



Jim O'Reilly
Jim Moseley
Tom Micek
Dave Dowding
Ernie Wahl

Reviewed Jim O'Reilly's use-case and got some discussion and comments:

1. We want the ability to execute a flownode independent of flow, e.g., during debug.

2. On section 1.2.2: test may point to DCLevels that require power up/down and therefore connect/disconnect but this testcase emphasizes other aspects of testflow behavior.

3. On section 1.5.3: there are issues with regard to variables storing measurement results:

    a. persistence (lifetime) of variables, e.g., per testprogram execution, per testprogram load

    b. rate of value refresh, e.g., per device, per wafer, per lot

    c. do Spec/Category/Selector permit using meas value as feedback, i.e., can a Category/Selector pick the measured value as one of its components ? Dave Dowding will look into this.

5. We need boolean flow control variables (not covered by Spec/Category/Selector).  Other types ?  For other purposes ?

6. We need to define the testprogram/executive interface, where the executive is the program that runs the prober or handler and invokes the testprogram and the testprogram program runs the testflow(s).


-----------------------------------------------------------------------
Ernie Wahl           Agere Systems              Tel:   610.712.6720    
Computer-Aided Test  22F-218B, 555 Union Blvd   Fax:   610.712.4235    
                     Allentown, PA, 18109       Email: ejwahl@agere.com
-----------------------------------------------------------------------