Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [10GMMF] 62MMF connector loss and draft test link config

do you have any data that would support your suggestion Paul?


tel: 1 408 524 5110
fax: 1 408 739 0568

Jonathan King
Director, Optical Systems
BigBear Networks
345 Potrero Avenue
Sunnyvale, CA 94085

-----Original Message-----
From: Paul Kolesar [mailto:PKOLESAR@SYSTIMAX.COM]
Sent: Thursday, August 19, 2004 8:30 PM
Subject: Re: [10GMMF] 62MMF connector loss and draft test link config


thanks for this work.  The model I have for 62.5 agrees with your analysis for the steady state launch condition.  Please confirm that in your model the steady state condition represents a 70/70 launch (i.e. 70% of maximum core diameter and 70% of maximum NA).  

I have a comment regarding the 7 um limit. The 7 um value was chosen for the OM3 work because it represented 0.5 dB for 50 um fiber under steady state conditions.  The remaining 0.25 dB needed to reach the 0.75 dB limit was allotted to mechanisms other than lateral offset.  The equivalent offset for 62 um fiber is 9 um from your graph.  Thus connectors need to be of tighter tolerance for 50 um fiber than for 62 um fiber.  As product lines of cabling vendors in North America and other parts of the world have shifted to include a larger mix of 50 um fiber, the tolerance for connectors needed to be tightened to maintain good performance.  Fortunately progress in connector technology permitted this.  The result is that over time connectors have gotten better.  This leads to an interesting issue when dealing with legacy plant. The older plant likely has poorer connectors due to both tolerance and wear.  I think this leads to a need for considering different values for legacy 50 and 62 um plants.  To address these considerations, I would suggest that the limit for 62 um fiber be set at 9 um and that for 50 set at 7 um.

Paul Kolesar
1300 East Lookout Drive
Richardson, TX 75082
Phone:  972.792.3155
Fax:      972.792.3111


David Cunningham <david_cunningham@AGILENT.COM>
Sent by:

08/18/2004 02:24 PM
Please respond to "IEEE 802.3aq 10GBASE-LRM"

        cc:        (bcc: Paul F Kolesar/CommScope)
        Subject:        [10GMMF] 62MMF connector loss and draft test link config

Dear All,

As promised on todays Fiber Channel Ad Hoc I attach a PDF file containing the following information:

* My calculated graphs of connector loss versus offset for overfilled launch, steady state launch and 23 um offset single mode launch.

* The agreed draft of the worst-case test configuration for channel time variation measurements with comments from our call to document our reasoning behind the chosen configuration.