Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [10GMMF] Loss of worst case test configuration



Jorg,
Nice results. Thank you for his contribution. Besides the 70/70 case, it is interesting to see how the loss due connector offset up to 7Ám is almost negligible (less then 0.1dB at 7mm) if the offset launch up to 20Ám is applied and instead how sudden the situation degrades as soon as 23Ám offset launch is applied.

Best regards

Stefano

-----Original Message-----
From: owner-stds-802-3-10gmmf@listserv.ieee.org [mailto:owner-stds-802-3-10gmmf@listserv.ieee.org] On Behalf Of Kropp Joerg (IFFO MOD CE)
Sent: Dienstag, 31. August 2004 21:03
To: STDS-802-3-10GMMF@listserv.ieee.org
Subject: [10GMMF] Loss of worst case test configuration


Hi everyone,
In the discussion for the worst case test configuration there was some discussion about the loss of connector transverse offsets if the 70/70% launch condition (which should represent the so called steady state power distribution) is applied. I calculated the connector loss vers transverse offset for various launch conditions including the 70/70% launch. It turns out that the loss with the 70/70% launch is somewhat larger than the 23Ám offset launch. Therefore the total loss of our worst case test configuration would be larger than 1,5dB if such 70/70% launch would be applied.

It is common agreement today to use the defined offset patchcord and I do not want to change that but I want to share the results for the sake of completeness because it shows the sensitivity of our selection on the launch conditions.

Joerg



Infineon Technologies Fiber Optics GmbH
MOD CE
Dr. Joerg-R. Kropp
Senior Staff Expert
Wernerwerkdamm 16
D-13629 Berlin / Germany
Phone -49-30-85400-4918
Fax     -49-30-85400-4900
Mail     joerg.kropp@infineon.com