Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

RE: Equalization


If you are interested in the potential for signal processing techniques
to mitigate the interference effects in optical links, it will be very
useful for this group to collect some data. Specifically, if this group
would collect receiver sample data at atleast 2X (preferably 4X)
the baud rate, it would facilitate a lot of analysis. A number of signal
processing people who have been monitoring this group (including yours
truly) would be willing to calculate the potential benefit of any
equalization techniques and present the data on this reflector and at
the next meeting.

Since I have seen numerous eye diagrams presented to this
group, it should be possible to use the same lab setup and
a digitizing oscilloscope to collect this data. For this data to be useful,
the transmitted bits should be random and at least a few thousand baud
intervals of samples to allow extraction of the necessary parameters. The
sampling could be completely asynchronous as long as the sample rate is at
least twice the baudrate. Given this data, it is relatively straightforward
for those in the signal processing field to calculate the effectiveness of
equalization techniques. Numerous techniques are available to combat linear
and certain types of non-linear deterministic effects. The random effects,
if any, would take more work (and more data).

	Any volunteers?



 Kishore Kota
 Cicada Semiconductor Inc.
 811 Barton Springs Road, Suite 550
 Austin, Texas  78704

 512-327-3500 x104 voice
 512-327-3550      fax

> -----Original Message-----
> From: owner-stds-802-3-hssg@xxxxxxxx
> [mailto:owner-stds-802-3-hssg@xxxxxxxx]On Behalf Of Jonathan Thatcher
> Sent: Thursday, July 20, 2000 7:51 PM
> To: 'vipul.bhatt@xxxxxxxxxxx'; HSSG
> Subject: RE: Equalization
> Vipul,
> Not a punishment, just something I've been noodling over and
> wasn't sure if
> we were ready to ask.
> Specifically, I have been curious about the potential for the DMD response
> (assumes no launch control) to be non-deterministic. In short,
> what happens
> to that thing we used to call "modal noise" in a DMD-sensitive system?
> It seems likely that a simple experiment could be created if one
> had a BERT,
> Scope, LX transceiver, and a spool of the "bad DMD fiber" to see if the
> general shape of the pulse into the Rx would change under various types of
> "abuse." I'm not talking about dynamic changes like wrapping it around a
> mandrel or anything that would not be "typical" in an installed
> infrastructure. Just fiber blowing in the wind, the temperature of the Tx
> changing... stuff like that.
> Now, you could argue that these types of things would be "random"
> in nature.
> Even so, if the response of the system to these changes is significantly
> non-linear, then the effect could end up unmanageable. I hope otherwise.
> jonathan