Clause 51: I/O types for Sync_Err and LOS
Repost ... see below.
Quake Technologies, Inc.
50 Airport Parkway, San Jose, CA. 95110
Tel: 408-437-7723 email: justin@xxxxxxxxxxxxx
Fax: 408-437-4923 internet: www.quaketech.com
In draft 2.0, there is now an optional signal for Sync_Err. In the inclusion
this for the XSBI, there was not an agreed upon I/O type for this signal.
I have put it as a signal ended line. I would propose either LVTTL or CMOS
Regarding the LOS ... same issue. There was no logic type indicated at
all from the on set. In this case however, the intent was to pass thru any
PMD LOS signal as is ... no qualification by the PMA. I can see leaving this
spec as is ... no I/O description ... as we are enabling the PMD to define
this. On the other hand I think it would be wise to have consistent I/O for
these two link status indicators. Again either LVTTL or CMOS is recommended.