Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: Clause 48: Errors after T.


Check_end performs this function. D2.3 add a call to the check_end
function in state DATA_MODE_START of the PCS Receive state diagram.

Best Regards,

Justin Gaither wrote:
> Everyone,
> During the Plenary, it was determined that we need to push an error that
> occurs after the /T/ back 1 column so that it is included inside the /S/
> and /T/ delimeters.  My question is, can we just push all errors back on
> column, or must we determine if it is in the column following a //T//?
> I could not find this in D2.3, where did it get put?
> Thanks
> --
> Justin Gaither                       Phone: 512-306-7292  x529
> RocketChips a Division of Xilinx     Fax:   512-306-7293
> 500 N. Capital of TX Hwy.
> Bldg 3                         email: jgaither@xxxxxxxxxxxxxxx
> Austin, TX 78746               WWW:
Richard Taborek Sr.     XAUI Sherpa     Intel Corporation    
Santa Clara Design Center     Network Components Division
408-496-3423     Fax: 408-486-9859     Cell: 408-832-3957
3101 Jay Street, Suite 110          Santa Clara, CA 95054