[802.3ae] XAUI spec for far-end load
1) Refering to IEEE Draft P802.3ae/D3.1, subclause 47.4.2, on page 345,
it is said "the far-end load for the compliance link is specified in
4.7.3.", I could not find that specification. Could you point out?
2) In Subclause 22.214.171.124, on page 340, it is said "Reference input
signals satisfy the far-end template given in Figure 47-10 and Table
47-4 when the signal source impedance is 100ohm +/- 5% ..." Should not
"signal source impedance" actually be "receiver input impedance"?
Thank you for your attention.