Clause 49 comments
Pat,
Just a few comments regarding clause 49. Sorry if these were
already brought up last week.
49.1.4.3 - page 159, line 13
The reference to serial-bit-oriented physical media does
not reflect the intended support of WAN WWDM implementations.
49.1.5, page 159, line 53
Change XSBI description from "10 gigaBit Interface" to
"10 gigabit Sixteen Bit Interface"
49.1.5, page 159, line 54
This can also be used with WAN WWDM so the description of
"a serial, physical interface" is not quite appropriate.
49.1.4.4 - page 160, figure 49-1
The reference to LX-, SX- and XX-PMDs should be replaced
with LR-, SR- and XR-PMDs
49.1.6 - page 161, figure 49-2
There should be a line from the BLOCK SYNC box to the
BER MONITOR box
49.2.1 - page 161, line 40
Insert the number 10 before Gigabit Media Indepndent Interface
49.2.2 - page 161, line 49
Replace "TXCn = 1" with "RXCn = 1"
49.2.4.3 - page 165, figure 49-5
The column of Input Data should use Zx rather than Cx. There
is not a 1:1 mapping from the Cx under Input Data to the Cx
under Block Payload
49.2.4.9 - page 166, line 52
Change "sent when an invalid" to "sent when invalid"
49.2.11.1.2 - page 169
line 18 - mt_valid should reference bits 0 & 1, not 65 & 64
line 28 - remove the word "with"
line 31 - superscript the "-4"
line 33 - bad definition for slip_done - cut & paste error
49.2.11.1.4 - page 169, line 53
superscript the 14
49.2.11.2 - page 170, figure 49-9
Keep hi_ber_cnt at reset value when not in frame_lock state.
49.2.11.2 - page 172, figure 49-11
in state E, replace "=" with "<=" in "rx_err=EFRAME_G"
Ben
--
-----------------------------------------
Benjamin Brown
AMCC
603-798-4115 - Home
bbrown@amcc.com
-----------------------------------------