RE: [802.3ae] some questions about mdio
The MDIO/MDC operate very similar to an I2C interface. The MDIO carries the
data in a serial stream. Within the data on the serial stream, there are
two bits used to indicate reads and writes. This information can be found
in Clause 22 of 802.3-2000 and in Clause 45 of P802.3ae.
Cheers,
Brad
-----Original Message-----
From: amyliya@hotmail.com [mailto:amyliya@hotmail.com]
Sent: Thursday, April 25, 2002 4:51 AM
To: stds-802-3-hssg@ieee.org
Subject: [802.3ae] some questions about mdio
hi,
I know that mdio is the management interface between the sta
and
phy,
but where the write and read command come from? And, if they is
determined by some register,then what the registers are and where
they come
from?
thank,
amyliya
_________________________________________________________________
???? MSN Explorer?http://explorer.msn.com/lccn/intl.asp