| Thread Links | Date Links | ||||
|---|---|---|---|---|---|
| Thread Prev | Thread Next | Thread Index | Date Prev | Date Next | Date Index |
|
Attached is the proposed resolution to comments from Lennart involving “shall be tested” – we plan to resolve this tomorrow (Tuesday) morning. General approach – change these to the formula “When texted using the test fixture shown in Figure xxx-yyy and the transmitter in test mode z, the transmitter …” See proposed resolutions to comments 301, 302, 308, 309, 310 attached, and example below using comment 301: Cl
146
SC 146.5.4.1
P
140 L
48
# 301 Comment Type
TR "Transmitter output voltage shall be tested using test mode 1 in combination with the test fixture shown in Figure 146-17." We can't put requirements on the tester, only on the device. SuggestedRemedy Rewrite the requirement: "When tested with the test fixture shown in Figure 146-17 in test mode 1, the transmitter output voltage shall ... <show some property>." Possibly the very next sentence already covers this. In that case, make the quoted sentence informative. PROPOSED ACCEPT IN PRINCIPLE. Change “Transmitter output voltage shall be tested using test mode 1 in combination with the test fixture shown in Figure 146-17. The transmitter output voltage shall be 2.4 V ± 5% peak-to-peak (for the 2.4 Vpp operating mode) and 1.0 V ± 5% peak-to-peak (for the 1.0 Vpp operating mode). " To: “"When tested with the test fixture shown in Figure 146-17 and the transmitter in test mode 1, the transmitter output voltage shall be 2.4 V ± 5% peak-to-peak (for the 2.4 Vpp operating mode) and 1.0 V ± 5% peak-to-peak (for the 1.0 Vpp operating mode).” George A. Zimmerman, Ph.D. President & Principal Consultant CME Consulting, Inc. Experts in PHYsical Layer Communications 1-310-920-3860 To unsubscribe from the STDS-802-3-10SPE list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-10SPE&A=1 |
Attachment:
zimmerman_3cg_01_1118.pdf
Description: zimmerman_3cg_01_1118.pdf