Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

RE: [EFM] RE: EPON TDMA



Title: RE: [EFM] RE: EPON TDMA

Ethernet has always had an inherent form of DBA in the fact it allows a station with traffic to send at up to the line rate or an arbitrated rate less than that.  However in a connectionless system there are no service contracts or allocations of that bandwidth, but bandwidth of the media is divided dynamically.  SLAs are features which do not belong in the Ethernet MAC layer, however dynamic bandwidth allocation is inherent within Ethernet and that is why Ethernet is so well suited for data traffic. 

By creating fixed timeslots in the upstream you are changing the nature of Ethernet.  Now the maximum bit rate of one station to burst upstream is limited to its timeslot.  I believe according to the AllOptic presentation this would be 25 - 50 Mbps/ station (without DBA).  This creates asymmetry which has never been an explicit form of Ethernet.

A new media for Ethernet should present similar characteristics of traditional Ethernets.  There is certain level of service which Ethernet has.  If you increase the latencies across the media ten fold, is it still Ethernet?  The end user will perceive a difference in service.

Ryan Hirth
Terawave Communications
rhirth@terawave.com
(707)769-6311



-----Original Message-----
From: jc.kuo@alloptic.com [mailto:jc.kuo@alloptic.com]
Sent: Friday, July 13, 2001 4:06 PM
To: glen.kramer@alloptic.com; zhangxu72@yahoo.com
Cc: stds-802-3-efm@ieee.org
Subject: RE: [EFM] RE: EPON TDMA




As PON is just a new media of Ethernet, the overall system will be a base on
"Switched Ethernet" architecture.
Under this architecture, bandwidth shaping and priority queuing will only be
done in the switch fabric. In the MAC and PHY, a mechanism which allow
flexibly assign the data rate may benefit the DBA implementation but DBA
algorithm will not be implemented as part of MAC and PHY layer function.

There is always trade-offs between delay and utilization. Reduce the guard
band and do the packet fragmentation will help the bandwidth utilization,
then the delay can be minimized. EPON is under the umbrella of Ethernet,
keep the Ethernet frame integrity is one of the religions of 802.3 team,
packet fragmentation is not considered as an option for the standard.     
 
JC Kuo
jc.kuo@alloptic.com
Alloptic, Inc.
2301 Armstrong St.
Livermore, CA 94550
Phone: (925) 245-7641
Fax: (925) 245-7601
www.alloptic.com


-----Original Message-----
From: glen.kramer@alloptic.com [mailto:glen.kramer@alloptic.com]
Sent: Friday, July 13, 2001 2:55 PM
To: zhangxu72@yahoo.com; glen.kramer@alloptic.com
Cc: stds-802-3-efm@ieee.org
Subject: [EFM] RE: EPON TDMA



Dear Xu,

I think I know what confused you in the presentation as I got several
similar questions.

Timeslot is not an analog to a cell. While, from the slide 4 in the
presentation you may conclude that one timeslot is only large enough to hold
one maximum size packet, that is not the case.  Timeslot in our example was
125 us, which equals to 15625 byte times.  Then you can see that in the
worst case it will have 1518 + 4(VLAN) + 8(preamble)+12(IPG) - 1 = 1541
bytes of unused space at the end of timeslot (assuming there is data to be
sent and no fragmentation).  With realistic packet size distribution (like
the one presented by Broadcom), the average unused portion of the timeslot
is only about 570 bytes.  That gives channel efficiency of 96%, or
accounting for 8 us guard bands - 90%

DBA is a separate question.  While it may be important for an ISP to have
DBA capabilities in their system, I believe it will not be part of the 802.3
standard.  But a good solution would provide mechanisms for equipment
vendors to implement DBA.  These mechanisms may include, for example, an
ability to assign multiple timeslots to one ONU or to have timeslot of
variable size. Grant/Request approach is trying to achieve the same by
having variable grant size.

Having small timeslots will not solve QOS either.  Breaking packet into
fixed small segments allows efficient memory access and a cut-through
operation of a switch where small packets are not blocked behind the long
ones (and it assumes that short packets have higher QOS requirements).  In
such a distributed system as EFM is trying to address (distances in excess
of 10 km) the gain of cutting through is negligible comparing to propagation
delay or even the time interval before ONU can transmit in a time-sharing
access mode (be that TDMA or grant/request method).


Thank you,

Glen

-----Original Message-----
From: xu zhang [mailto:zhangxu72@yahoo.com]
Sent: Thursday, July 12, 2001 7:01 PM
To: glen.kramer@alloptic.com
Cc: stds-802-3-efm@ieee.org
Subject: EPON TDMA

hi, glen:
 I had seen your presentation file about EPON TDMA in
PHY, it help me a lot to understand your EPON system.
We had developed the first APON system in china, when
I think of the TDMA of EPON, I think though the uplink
data rate is 1Gbits/s when shared by 16 or 32 users is
still not enough, so the dynamic bandwidth
allocate(DBA) protocal must be a requiremant
especially when take care of the QoS performance. In
DBA protocal, in order to achieve high performance the
time slot need be to small, I think why not we divide
the ethernet packet to 64 byte per solt, it is often
used in ethernet switch when store packet in SRAM.

best regards
xu zhang


__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/