Submitting Test Data

IEEE 1349-2001 included motor test data through the end of 2000.  

This is a request for any manufacturer with motor test data (which includes rotor temperature) to please submit the data to Lorraine Padden, IEEE 1349 Chair, using the file link below.  The data submitted should be data that was collected after 2000 and/or not included in the current standard IEEE 1349-2001.

The scope of IEEE 1349 includes:  

Three-phase and single-phase AC synchronous and induction electric motors in fractional ratings

0.18 kW (1/4 hp) and larger are covered in this Guide. Primary emphasis is on the use of open or

nonexplosionproof or nonflameproof enclosed motors in Class I, Division 2 and Class I, Zone 2

locations as covered in NFPA 70-2005.   This Guide does not cover AC wound rotor

motors and DC electric motors. Motors installed in locations other than Class I, Division 2 and

Class I, Zone 2 as covered in NFPA 70-2005 are not covered in this Guide. 

To Submit data:

1.  Download the Excel spreadsheet by right clicking below and "save as" to your computer

2.  Enter data in the spreadsheet in the "Motor Only" or the "Motor & ASD" Tabs

3.  Enter the data under the subsection where appropriate

4.  Save file as "Manufacturer-date"

5.  E-mail the file to Lorraine Padden, IEEE 1349 Chair, paddeneng@aol.com

Motor Test Data Spreadsheet

In addition to the Excel spreadsheet with the data, submit a signed and dated copyright release form using the company letterhead. Note manufacturer/source will be kept confidential.  

To Submit copyright release:

1.  Download the Word document by right clicking below and "save as" to your computer

2.  Put the letter on the company letterhead

3.  Complete the form 

4.  Save file as "Manufacturer-date"

5.  Send signed copy as shown on form

IEEE Copyright Release Form