Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

[STDS-802-11-TGBF] Discussion on measurement setup terminate frame format

Hi Cheng and other members who care about this topic,


As suggested by Ali, we may have “Terminate All” include two bits: terminate All NTB, terminate All TB. The reason is that additional 1 bit (small overhead) can provide selectivity as the use case on one side can stop without the other side.

For example, in order to save power or allocate more resource to communication services, a STA may want to terminate all use cases initiated by AP, and keep all the use cases initiated by itself.

This example is reasonable, because in the use cases initiated by AP, STA may only do a favour. But in the use cases initiated by STA itself, the sensing measurement and sensing result are important.


I’d like to hear your opinion on this change: “Terminate All” include two bits: terminate All NTB, terminate All TB.


Best regards,




This e-mail and its attachments contain confidential information from OPPO, which is intended only for the person or entity whose address is listed above. Any use of the information contained herein in any way (including, but not limited to, total or partial disclosure, reproduction, or dissemination) by persons other than the intended recipient(s) is prohibited. If you receive this e-mail in error, please notify the sender by phone or email immediately and delete it!

To unsubscribe from the STDS-802-11-TGBF list, click the following link: