Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

[802SEC] Re: stds-802-16-mobile: Creating Unique Identities for the two mobility PARs




Forwarded for a non-subscriber.

 -Bob
 

-----Original Message-----
From: "Avi Freedman" <avif@hexagonltd.com>
To: "Marianna Goldhammer" <marianna.goldhammer@alvarion.com>,
   "Mark Klerer" <M.Klerer@flarion.com>,
   "'Kiernan, Brian G.'" <Brian.Kiernan@interdigital.com>,
   <r.b.marks@ieee.org>
Cc: <stds-802-mobility@ieee.org>, <stds-802-16-mobile@ieee.org>,
   <stds-802-sec@ieee.org>
Subject: Re: stds-802-16-mobile: Creating Unique Identities for the two
mobility PARs  
Date: Mon, 4 Nov 2002 00:16:26 +0200

Dear M&M
I tend to agree with Mark's spirit, in the sense that a distinction can
be
made between the two mobility groups based on the fact that 802.16 is
working on adding mobility functionality to the 16a standard, while ECSG
is
an blank slate. But I also agree with Marianna that backward
compatibility
was never the issue.
Perhaps indicating the 250kmh speed in the 802.15 PAR conveyed the wrong
idea, and might have caused a misinterpretation of the intention.
However,
speed has to be included in the PAR, as it is an essential measure of a
mobile system performance. Maybe a minimal speed of 90kmh should be set
and
higher speed should be considered as "best effort"

Avi

----- Original Message -----
From: "Marianna Goldhammer" <marianna.goldhammer@alvarion.com>
To: "Mark Klerer" <M.Klerer@flarion.com>; "'Kiernan, Brian G.'"
<Brian.Kiernan@interdigital.com>; <r.b.marks@ieee.org>
Cc: <stds-802-mobility@ieee.org>; <stds-802-16-mobile@ieee.org>;
<stds-802-sec@ieee.org>
Sent: Sunday, November 03, 2002 12:17 PM
Subject: RE: stds-802-16-mobile: Creating Unique Identities for the two
mobility PARs


> Dear Mark,
>
> I think that we disagree on the 802.16 scope. We are not looking for
> "backward compatibility" with our existing 802.16a standard.
>
> We are looking to improve the existing 802.16a standard, to support
> high speed, high data rates mobility.
>
> We think that we can take advantage of > 80% of 802.16 MAC, by
adapting
>  it to support mobility.
>
> And we do not target "pedestrian mobility". We know, due to work done
>  within 802.16 SG, that even the existing 802.16a OFDM and OFDMA
>  PHY work at very high speeds.
>
> I think that a key difference issue is the data rate. We look to
converge
> the
> fixed and mobile wireless service, based on high data rates provided
by
> both BS and CPE equipment. We will be able to target mobile terminals,
>  as well as to provide mobile symmetrical feeding for moving "Hot
Spots".
>
>
> Regards,
>
> Marianna
>
>
> -----Original Message-----
> From: Mark Klerer [mailto:M.Klerer@flarion.com]
> Sent: Sunday, November 03, 2002 1:44 AM
> To: 'Kiernan, Brian G.'; 'r.b.marks@ieee.org'
> Cc: 'stds-802-mobility@ieee.org'; 'stds-802-16-mobile@ieee.org';
> stds-802-sec@ieee.org
> Subject: stds-802-16-mobile: Creating Unique Identities for the two
mobility
> PARs
>
>
> Roger, Brian
>
> In response to the SEC chair's request that we work toward defining
unique
> identities of the two mobility PARs, I would like to suggest the
following.
>
> The 802.16 Study Group has the charter of allowing the evolution of
802.16
> compliant systems toward supporting mobility. To that end it would
appear
> logical that changes to the PHY and MAC be fully backward compatible
with
> the existing specification and that no a priori statement be made
about
the
> station speed that can be supported by such a system. I would like to
> suggest that the PAR therefore focus on these aspects and that the
project
> scope be described as:
>
> To amend the 802.16 standard to support combined fixed and mobile
operation
> from within a single system. The extension will address PHY and MAC
changes,
> that are fully backward compatible, while supporting mobile subscriber
> operation and roaming between 802.16 base-stations or their sectors.
This
> amendment will allow high spectral efficiency (3~4 bits/s/Hz),
macrocell
> sizes and NLOS operation.
>
> The ECSG PAR's objective, on the other hand, is to develop a standard
that
> is optimized for broadband wireless data mobility without any a priori
> assumptions about the technologies used to realize that objective. The
PAR,
> therefore, states the design objective of developing a spectrally
efficient
> solution that will support mobility classes up to 250 Km/h. I believe
that
> there are no changes required in the wording of that PAR.
>
> In essence we then have two PARs with, one addressing the need for a
> solution optimized for full vehicular mobility and the other the need
for
> extending the capabilities of 802.16 systems to support a level of
mobility.
>
>
> This is a new proposal that I believe should allow the SEC to approve
both
> PARs. I am copying the two mobility groups in order to get their
reaction
to
> this proposal and see if they will agree to such PARs. If this is
acceptable
> we could formally revise the PAR on Monday or Tuesday and approach the
SEC
> on Friday with a consensus position.
>
>
> Regards
>
> Mark Klerer
> Chair - MBWA-ECSG
> 135 Route 202/206 South
> Bedminster, NJ 07921
>
> . E-mail: m.klerer@flarion.com
> (    Phone: 908-997-2069
> 6    Fax:     908-997-2050
>
>
> This mail was sent via mail.alvarion.com
>
>
************************************************************************
****
********
> This footnote confirms that this email message has been scanned by
> PineApp Mail-SeCure for the presence of malicious code, vandals &
computer
viruses.
>
************************************************************************
****
********
>